Apply 220 volts to motor (terminal 1 + 2) on timer Wait for 20 seconds then push reset button Wait for timer to reset (approximately 5 seconds) Setting time and day Push and hold down clock button. While holding down the clock button Push D+ repeatedly to adjust the current day Push H+ repeatedly to adjust the current hour Push M+ repeatedly to adjust current minute Release the clock button. The current time and day will now be set.

Programming timer
1. Push P button once (program 1 ON appears)
Push D+ repeatedly until desired day is reached,
Push H+ button repeatedly until desired hour is reached, push M+ repeatedly until desired minute is reached.

2. Push P button once again (program 1 OFF appears)
Push D+ repeatedly until desired day is reached, push H+ button repeatedly until desired hour is reached, push M+ repeatedly until desired minute is reached.

3. Push clock button once. Program 1 is now set.

For timer to operate automatically press manual button until auto appears on screen.

To operate timer manually press manual button until ON or OFF appears on screen.

Wiring:
Please note all electrical installations must be done by a qualified electrician.

Power, being 220VAC must be applied to the unit. Live to Terminal 1 and Neutral to Terminal 2

A 1.5mm wire must be briged from the live terminal to the centre terminal No. 4

The load must be connected to normally open terminal No. 5

Note: The Neutral of the load must be connected to the appropriate neutral bar, and not to the timer.

Please note: The current rating of the device is 16amps.

Please check if the device is inductive or a resistive load.

For a load that exceeds this rating please install the correctly rated domestic contactor.